[ Pobierz całość w formacie PDF ]
.Inspect the bores from both ends of the barrels forresidue caused by leading and plastic shot cups.This residue will form23 streaks that run parallel to the inside of the bore.Slight residue streaksare common place and will not affect the performance of your shotgun.If lead or plastic residue appears to be excessive it can be removed bybrushing the bores with a brass brush attached to the cleaning rod.First apply gunpowder solvent to the brush end of the cleaning brush.Insert the cleaning rod into the chamber end of the bores.Push thebrush completely through the shotgun bore before pulling it backwardsto avoid breaking the bristles on the brush.Continue this scrubbingaction until the bores are clean.When all fouling and residue is removed, push a clean dry patch throughboth bores with the cleaning rod to remove any remaining debris or sol-vent.When the bores are free of all solvent and debris, insert a lightlyoiled patch and lubricate the bores.Wipe the metal surfaces of the barrels, forearms and receiver with aclean rag.Lightly oil the metal parts on the receiver hinge, barrel lugsand the forearm brackets.Notes24 Notes25 QUICK REFERENCEFOR YOUR MERKELMODEL NUMBER:________________________GAUGE:_________________________________BARREL LENGTH:_________________________CHOKE:_________________________________SERIAL NUMBER:_________________________DATE PURCHASED:_______________________26 U.S.IMPORTERGSI Incorporated, 108 Morrow Ave.,P.O.Box 129, Trussville, Al 35173.Telephone (205) 655-8299Fax (205) 655-7078www.GSIfirearms.com
[ Pobierz całość w formacie PDF ]