[ Pobierz całość w formacie PDF ]
.16).(1) Disconnect and isolate the battery negativecable.(2) Remove the right front fender inner liner.Referto Front Fender in Group 23 - Body for the proce-dures.(3) Unscrew the antenna mast from the antennabody (Fig.17).Fig.16 Sound Bar Remove/InstallFig.17 Antenna Mast Remove/Install - Typical 8F - 14 AUDIO SYSTEMS ZJREMOVAL AND INSTALLATION (Continued)(4) Remove the antenna cap nut and adapter usingan antenna nut wrench (Special Tool C-4816) (Fig.18).Fig.18 Antenna Cap Nut and Adapter Remove/Fig.20 Right Cowl Side Trim Panel Remove/InstallInstall - Typical(8) Remove the two screws that secure the right(5) Lower the antenna body and cable assemblycowl side trim panel to the right front door openingthrough the top of the fender far enough to accesstrim.the antenna body by reaching up into the rear of the(9) Remove the right cowl side trim panel from theright front fender wheel housing (Fig.19).right cowl side inner panel.(10) Reach under the right end of the instrumentpanel to unplug the coaxial cable connector near thejunction block.Unplug the connector by pulling itapart while twisting the metal connector halves (Fig.21).Do not pull on the cable.Fig.19 Antenna Body and Cable Remove/Install(6) Remove the fuse access panel by unsnapping itfrom the right cowl side trim panel.(7) Remove the push nut that secures the rightcowl side trim panel to the junction block stud (Fig.20).Fig.21 Antenna Coaxial Cable Connector - Typical ZJ AUDIO SYSTEMS 8F - 15REMOVAL AND INSTALLATION (Continued)(11) Reach up into the rear of the right frontSPECIAL TOOLSfender wheel housing to disengage the coaxial cablegrommet from the hole in the right cowl side outerANTENNApanel.(12) Pull the coaxial cable out through the rightcowl side outer panel.(13) Remove the antenna body and cable from thevehicle.(14) Reverse the removal procedures to install.Tighten the antenna cap nut to 8 N·m (70 in.lbs.).Tighten the antenna mast to 3.3 N·m (30 in.lbs.).Antenna Nut Wrench C-4816
[ Pobierz całość w formacie PDF ]